UNI CHIP FITTING AND SET UP
05 September 2003, 02:32 PM
#1
Scooby Regular
Thread Starter
Join Date: Oct 2002
Posts: 914
Likes: 0
Received 0 Likes
on
0 Posts
HI DOES ANY ONE know of any one able to fit and set up a dastek unichip in the NW-UK or as near as posible, would travel if the dealer has a good reputation for this type of work ,thanks mark
09 October 2003, 01:01 PM
#4
Former Sponsor
iTrader: (4)
Join Date: Jul 2003
Location: @Junc 12, M40 Warwicksh; 01926 614522 CV33 9PL -Use 9GX for Satnav. South Mids Alcatek ECu dealer
Posts: 6,377
Likes: 0
Received 3 Likes
on
3 Posts
Owen's gets my vote every time. Dino really knows his stuff and the mapper - Mark is faultless. l took a customers car [an early RA ] there in early August. On the way in it had 251.8 BHP and 205.6 Ft Lbs of torque
AFTER, it had 284.5 BHP and 259 odd Ft Lbs of torque. AND at better more usable revs.
See if you can guess how it went and how happy my customer is??
A lot of gain was due to low boost pressure, before it had .6 of a bar, after: it peaked at 1.2 bar.
Apart from the VERY LONG waiting list to get in there it's worth every penny - I'm sold on the deal.
David API engines
Edited to make a bit more sense with dots and comma's in the right places - Durr
[Edited by APIDavid - 9/10/2003 1:03:19 PM]
AFTER, it had 284.5 BHP and 259 odd Ft Lbs of torque. AND at better more usable revs.
See if you can guess how it went and how happy my customer is??
A lot of gain was due to low boost pressure, before it had .6 of a bar, after: it peaked at 1.2 bar.
Apart from the VERY LONG waiting list to get in there it's worth every penny - I'm sold on the deal.
David API engines
Edited to make a bit more sense with dots and comma's in the right places - Durr
[Edited by APIDavid - 9/10/2003 1:03:19 PM]
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
33
29 August 2017 07:18 PM
Scott@ScoobySpares
Full Cars Breaking For Spares
7
14 December 2015 08:16 AM