Engine wanted
#1
Anybody know of a good source of 2nd hand engines?
I need a 'new' engine after my crank has been 'lost'. I don't/can't pay STUPID money for new parts. So I have to go the 2nd hand route.
I need a 'new' engine after my crank has been 'lost'. I don't/can't pay STUPID money for new parts. So I have to go the 2nd hand route.
#3
Where has your crank gone? Can't you repair the engine that you have - I would have thought that this would be the better option. I may be able to find a crank for you that you would have to have ground, and then use over size bearings.
Let me know if I can help.
David
Let me know if I can help.
David
#4
The crank has too much end float...
The rods are apparently shot too...
Piston #4; the ring land on the compression ring failed and broke away(bore wash)...
really bad state...
APi want either 1400 or 1700 for an engine.
[This message has been edited by Miserable (edited 09 April 2001).]
The rods are apparently shot too...
Piston #4; the ring land on the compression ring failed and broke away(bore wash)...
really bad state...
APi want either 1400 or 1700 for an engine.
[This message has been edited by Miserable (edited 09 April 2001).]
Thread
Thread Starter
Forum
Replies
Last Post
Bazil_SW
Engine Management and ECU Remapping
24
21 September 2015 11:55 PM