WinXP - create incoming connection - crashing
#1
WinXP - create incoming connection - crashing
Whats the best way to repair the "routing and remote access service" for WinXP ?
Every time I try to setup an incoming network connection I get this:
Error Dialogue box says:
"ncoming connections depend on routing and remote access which was unable to start"
if I go into services and try to manually start this it says
"error 127: routing and remote access is unable to start"
Every time I try to setup an incoming network connection I get this:
Error Dialogue box says:
"ncoming connections depend on routing and remote access which was unable to start"
if I go into services and try to manually start this it says
"error 127: routing and remote access is unable to start"
Last edited by CodeKey@Lisan; 13 May 2004 at 03:18 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM