Dual Channel STILL not working
#1
Scooby Regular
Thread Starter
Join Date: Dec 2002
Location: Sunny BELFAST
Posts: 19,408
Likes: 0
Received 0 Likes
on
0 Posts
got the board, memory arrive this morning. fitted the corsair xms 3700 (matched pair btw for deffo coz i ordered from overclockers) onto my asus board. put one module in DIMM1 and the other in DIMM3. memory frequency is now 205Mhz but still in single channel mode
anyone (Jay,Si,nick et al) have any ideas? do i need to change summat in the BIOS or should the memory be recognised as dual channel in these slots?
cheers
sinky
anyone (Jay,Si,nick et al) have any ideas? do i need to change summat in the BIOS or should the memory be recognised as dual channel in these slots?
cheers
sinky
#2
if its ANY help I had this problem. I've got the same board but at the moment PC2700 DDR. I was getting 'Single Channel Mode' on boot so I cleared my CMOS and it cured the problem. Not saying this will work for you tho.
Marc
Marc
Thread
Thread Starter
Forum
Replies
Last Post
JonMc
Subaru Parts
22
06 February 2016 09:50 PM
Bazil_SW
Engine Management and ECU Remapping
24
21 September 2015 11:55 PM