Snow Foam or shampoo ??
#1
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: Jun 2008
Location: Reigate Surrey
Posts: 2,656
Likes: 0
Received 0 Likes
on
0 Posts
Snow Foam or shampoo ??
Hi guys I have just got hold of a Gilmour Foamaster pro Foam Gun from Ebay,I was wondering what the best stuff to use with it is ?
I have seen that you can get proper snow foam from some detailer outlets (not PB tho) Is this the best thing your meant to use or can I just use my Meguiars Hyper Wash shampoo
I have seen that you can get proper snow foam from some detailer outlets (not PB tho) Is this the best thing your meant to use or can I just use my Meguiars Hyper Wash shampoo
#3
megs hyperwash ordinary shampoo dont come close, try http://www.cleanyourcar.co.uk/
Last edited by RED2; 30 July 2009 at 11:12 PM.
#4
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: Jun 2008
Location: Reigate Surrey
Posts: 2,656
Likes: 0
Received 0 Likes
on
0 Posts
megs hyperwash ordinary shampoo dont come close, try Clean Your Car - car care products UK
What pre clean snow foam tho there are a few to chose from, can you recommend one of them ?
#7
Former Sponsor
iTrader: (3)
Join Date: Feb 2006
Location: AB51 0TH
Posts: 2,562
Likes: 0
Received 0 Likes
on
0 Posts
To clarify, Hyper Wash is a snow foam, not a shampoo, but it can be used as a shampoo if you wish. When using it with a Gilmour, use as follows...
Directions for use: Remove the reservoir lid and pour or pump approximately 200 ml of Meguiars Hyper Wash into the bottom of the reservoir, then fill the reservoir to the top with hot water. Then refit the reservoir lid and shake gently to mix the solution before finally attaching your hose - then squeeze the trigger and adjust the top dial on the reservoir lid until you get the desired foam thickness.
Directions for use: Remove the reservoir lid and pour or pump approximately 200 ml of Meguiars Hyper Wash into the bottom of the reservoir, then fill the reservoir to the top with hot water. Then refit the reservoir lid and shake gently to mix the solution before finally attaching your hose - then squeeze the trigger and adjust the top dial on the reservoir lid until you get the desired foam thickness.
Thread
Thread Starter
Forum
Replies
Last Post
oilman
Trader Announcements
15
01 October 2015 11:55 AM