what settings to use
13 January 2009, 07:28 PM
#1
Scooby Regular
Thread Starter
iTrader: (7)
Join Date: Jul 2008
Location: warwickshire
Posts: 331
Likes: 0
Received 0 Likes
on
0 Posts
what settings to use
hi guys
have just purchased some snow foam and a foam lance from ultimate finish,just after advice on what setting to use on the gun it is a gilmour foammasterII pro foam gun and on the top the settings go from 0-5 for the foam/water mixture ,whats the best number to have it on for good thick foaming as my car is coverd in salt/crud at the moment and i have never used these foam guns/mixtures before.
cheers in advance
have just purchased some snow foam and a foam lance from ultimate finish,just after advice on what setting to use on the gun it is a gilmour foammasterII pro foam gun and on the top the settings go from 0-5 for the foam/water mixture ,whats the best number to have it on for good thick foaming as my car is coverd in salt/crud at the moment and i have never used these foam guns/mixtures before.
cheers in advance
16 January 2009, 10:23 AM
#2
Former Sponsor
iTrader: (3)
Join Date: Feb 2006
Location: AB51 0TH
Posts: 2,562
Likes: 0
Received 0 Likes
on
0 Posts
Totally depends on your water pressure and what shampoo/foam agent you are using. As a general rule of thumb, if you are using a standard shampoo fill the bottle a quarter full with it and add warm water to the top, then start on a middle setting (2-3) and adjust up or down until the foam level is spot on. If you are using a snow foam style product follow exactly the same method but add just 1cm of product to the bottle.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM
