muddy

I did this engine bay detail for a customer who is a Midland Scoobies member. Done this weekend gone..

Subaru Impreza STi...

Before Pics






After/finished pictures:








I used a combination of MPC, P21S Auto Wash to remove the dirt, my secret formula, Aerospace 303 Protectant for the plasitcs, Autoglym Rubber and Autoglym polish for the paintwork.

All done by hand with only a little water to rinse off now and again.

Took 3 hours in total.

Enjoy

Muddy

maydew

iTrader: (9)

mate that looks wicked well impressed would love u to do mine

scoobyverysoon

iTrader: (1)

nice that m8

Damocell

iTrader: (1)

That is very impressive mate, top attention to detail.

But not to be too picky isn't that a WRX engine bay not an STI?

Damo

pippyrips

i think you rubbed a little too hard and took the red paint off the manifold

out if interest are you running the standard air intake set up and have just changed the inlet pipe or is something else going on there?

COLZO

Was thinking that myself. Good job anyway.

muddy

Thanks for the comments guys.

Having been in the around Subaru's longer than most I should have seen the obvious signs

The Sti on the intercooler threw me a little.

Never mind.

Pippyrips -- It's a customer's car not mine, but I think it's a replacement zerosports pipe.


Muddy

Rich @ PB

iTrader: (3)

Nice work Craig, excellent work!

Pete

Good job fella..