Hi all
I,m decat ting the mid pipe tomorrow but I'm struggling to find a gasket that fits between the downpipe and mid pipe , it looks like a standard one but its a bit longer , I've had a standard up to it but the holes on the standard gasket fall short on the holes on the mid pipe , does anybody know where I can get one from or should I just make the holes on a standard one longer and use some high temp gasket seal with it .
Thanks in advance . Kev

 

Sounds like you might need a cone gasket.

 

You need a subaru cone gasket. What size exhaust are you fitting?

 

It a 2.5 bore , it's not the cone gasket or some call it a donut gasket that's at the end that connects to the centre section , this is the other side that connects to the downpipe where the cat is and it's a flat end .
Here's a picture , I'm after the one titled "this one"

 

Bump

Here's a picture of the standard gasket against a cardboard cutout of the one I'm after .