ok car is down at scoobyclinic getting solaris installed etc anyway they stuck it on the dyno and I was told its only producing 286bhp. Now I thought being a JDM hawkeye it would be more towards the 300 mark, I was told it was 320 but always expected a little below that. Im I mistaken about the power output???

Chris

 

About right for a standard un-mapped car I would have thought

 

Different dynos give different readings etc. Should be 280 ish albeit most say the JDM's are higher. My old Spec C (MY05) came in at 294bhp as nature intended which did disapoint me initially (was also expecting about 320!). Few mods later though & she was about 375

TX.

 

well thats good to know lol

 

not another thread on JDM models, use the search option

 

My old MY03 spec c ran 288bhp originally with about 1800 miles on the clock, by 10k she was pushing 316bhp this was with a panel filter though.
Most likely your car's mulitiplier has knocked itself back due to the fuel, hence you are seeing lower bhp figures, but note that anything over the standard 276 quoted BHP figure is a bonus 320bhp isnt common, more in the region of 310.

Tony

 

so what does it run now the solaris is mapped in????

 

well work is being done atm so will find out next couple of days

 

Waste of money in a new age JDM car (these ecu's are the best subaru factory ones)
Spend the money on the suspension instead

Tony

 

Mine was mapped before mods @ 309bhp

After H&S 3" System (100 cell cat), Green filter, Fuel pump, AF - remap 333bhp & 378ft/lbs.

Not a great difference in BHP but it's the torque that counts

 

JDM Rule....UK suck
Only joking

 

Getting her back tomorrow putting out 356bhp now with solaris ecu!

Very happy cant wait to drive now

 

Lucky git Have fun & don't crash it