Can anyone advise the easiest (and most accessable)way to tap into the lambda (for an AFR meter)on a MY96. I would like to aviod having to dismantle half the car to fit the meter.

Thanks


Martin

 

You only need to take five mins to get to the ECU and snap lock one wire and run it to where you are mounting the AFR meter. Also need a power feed - plenty about all over the car.

 

John - the $64,000

Do you know which wire it is on a 96 (I'm ok getting a feed and a ground). I don't want to fit the dawes until the AFR is wired in (would like to fit the dawes soon though to restore the torque lost with the 3" exhaust).

thanks

Martin

 

Not personally, but it has been discussed I think in amongst the multitude of thread. You could ask Scott T or Cosie Convert - I think there was a picture doing the rounds.

I would much rather tap at the ECU rather than in the engine bay in extreme environment. Our 4 year old 40000 mile Pug 406 recently broke down because of corroded wires in the engine bay that had presumably been damaged when some work had previously been done.

For the EBC final install I will be soldering all my connections at the ECU and insulating. For an AFR snap locks are fine - if it fails you will see.

 

Thanks John. I'll get searching.

Martin

 

mrp.

Try here.

Not sure if it helps, pics of a 95 ECU

Mole

 

Thanks Mole, that was just what I was after.



Martin

 

Snap locks are the very worst thing to use, always solder otherwise problems will result for sure, even temporarily.

 

I already had one of my temporary connections fail with a snap lock and even worse it was temperamental. My excuse for using them was to try and work out which wires I would need to cut first, but I should have soldered them from day 1. When the weather improves (no garage!) I will solder everything including the AFR meter.

 

4th wire from right (which is in the 6th slot, as 1 and 5 are unused)