I have just bought a 300zx maf complete with wiring plug, to fit to my MY00 UK turbo.

Can anybody tell me which way round to connect the wires on the plug to the existing wires in the loom ?

Thanks

 

notes show:

300 ZX MAF connector has 6 pins A-F:
A - Not Used
B - MAF Output Signal
C - Gnd
D - Gnd
E - +12V
F - Not Used

Subaru 92-96 MAF Connector has 5 pins:
1 - +12V
2 - Gnd
3 - Sensor Gnd
4 - MAF Signal
5 - Not Used

 

I would like to know how to wire it into the MY00 loom though.

 

You re very close

97-98 MAF
Yellow/Green = +12Vdc
Black/green = Minus/Ground
Pink = 0-5V Signal

 

I hope once you've done this that you're getting the car remapped as you'll need to rescale the MAF.

 

Yes, i will be adjusting the airflow curve to suit the new MAF

...Still need to know what the wiring is on the MY00 loom

 

MY99 MAF, 5 pin.

2 = +12v (Yellow)
3 = Gnd
4 = Gnd
5 = Signal (Green)

 

Thanks for the info Andrew.

I presume it makes no difference which way round you connect the 2 ground wires?

 

Doesn't seem to.

I'm surprise you didn't go for one of the 90mm Nissan MAFs to make fitting easier?

 

I've been on the lookout for a Q45 Maf for ages, but can't seem to find one

 

YHPM.