Can someone tell me the easiest place to make the pipework connections for the AVCR on my newage and also the best place to mount the solenoid valve and pressure sensor!

Cheers

 

remove original pipes from boost solenoid to turbo.. two pipes.

mount the boost solenoid and map sensor on the drivers side inner wing.

Run the boost solenoid pipe from the COM connection to the wastegate solenoid.. (round cylinder on the top of the turbo) and the other boost solenoid pipe to the output nipple on the turbo. Should be obvious where they are having taken them off previously etc..

Use a T piece to connect the AVC-R MAP sensor into the original map sensor pipe.. the problem at this point it describing this sensor to you if you have no idea which one it is.. It looks similar to the AVC-R MAP sensor only it is square.

Simon

 

Top Bloke !! Thankyou very much!!

 

no problem.

 

Except that he has a new age so no external MAP sensor

 

smart ****! lol

okay so he need to find another take off from the manifold for the AVC-R MAP sensor then.

Simon

PS: Andrew , reply to your emails!

 

Can i take off from the dump valve pipe where my boost gauge is for this map sensor?

 

Yes