Hi all,

I have a H&S downpipe to fit, but didn't get any gaskets with it. I'd like to replace them at the same time as fitting the new one. Which gaskets will I need and are they a dealer only part?

Thanks,

Karl

 

Not quite sure if they're available from Motor Factors..

But i paid around £9 from a dealer for my Turbo/exhaust gasket.

Johnny

 

Thanks for the reply

So is it just the one gasket I need, or do I need to replace the one to the manifold/block too? And what about the small one where the center section joins? Is it worth just replacing them all?

 

I had the up & downpipe changed and genuine gaskets from subaru are £10 each

Phil

Edited to say that, you definatley need new gaskets for the turbo end but depending on the car you mite be OK with the others

[Edited by MadGrip - 12/19/2003 10:38:54 PM]

 

For a true fit it would be best to replace them all, nothing worse than having a leak & having to do the job all over again with a new gasket.

You won't have to repace the donut gasket though as these are good for many uses

 

donut gasket = Downpipe to center section

 

where do you get the gaskets from other than subaru ?

 

got all the Gaskets you guys reckon I'm gonna need today from my local Subaru dealer. £28 quid for the two manifold gaskets and the turbo gasket

Thanks for the advice. Incidently I phoned around a number of motor factors and none of them would sell me these gaskets. They all said that it was a main dealer part

Thanks again!