Where's a good place to take the boost level from for a mech. gauge ?

I've included this piccy, as there appears to be a stopper of some kind on a possible candidate ...

Or should I use the T-Piece (Where into &gt

Cheers,

Mark



[Edited by markwild - 8/29/2003 8:01:10 PM]

[Edited by markwild - 8/29/2003 8:02:43 PM]

 

You're spot on there, pull off that blanking tube and fit the pipe to the boost gauge to the nipple underneath.

Andrew...

 

Cheers - I started to have a go, but ITS BLOODY DARK !

I'll try again tomorrow !

Mark

 

Hmm, fitted, but buzzes !

Spoke to Jamie at JWR and I've missed the Y Piece out - but I've no instructions...

Any clue to how to fit ?

Mark

 

what guage is it...?

It should work fine off that port....

 

Its an AVO gauge - Take a look at my thread above, sounds like the buzzing is correct, when no restrictor is fitted.

Any ideas to the position of this would be most welcome....

Mark