Trying to remove the clutch pivot arm pin

Reply Subscribe

Thread Tools

Search this Thread

Aug 9, 2003 | 02:30 PM

D.C

Thread Starter

Scooby Regular

Joined: Jul 2003

Posts: 131

Likes: 0

From: Staffordshire

I am trying to remove my clutch pivot arm pin on a 94 wrx!
i have tried to wind a 6mm bolt through but its snapped off! Has anyone got a picture of the arm assembly as this will be a great help!? or any suggestions??

Aug 9, 2003 | 05:21 PM

stockcar

Scooby Regular

Joined: Mar 2002

Posts: 6,831

Likes: 424

From: north east

all you should do is wind in a bolt "finger tight" and ease out!!
not sure what you'll do now if you can't draw the pin.....
alyn - asperformance.com

Aug 9, 2003 | 07:00 PM

David_Wallis

Scooby Regular

Joined: Nov 2001

Posts: 15,239

Likes: 1

From: Leeds - It was 562.4bhp@28psi on Optimax, How much closer to 600 with race fuel and a bigger turbo?

hmm Suggest you weld a nut to it now!

David

Aug 10, 2003 | 03:08 PM

tweenierob

Scooby Regular

Joined: Mar 2002

Posts: 4,338

Likes: 0

From: Fcon Power Writer

Lol either that or smash the bell housing to bits with a big hammer

Seriously though, if you can get hold of another release bearing you can pull the box off by bending the tabs on the bearing.
It is hard but i have done it, the arm is much stronger than the bearing tabs.

Rob