Cobra exhausts
18 April 2012, 06:01 PM
#31
Cobra's my favourite at the minute. At the end of the day its a mandrel bent stainless exhaust, 316 steel like all the others. The welds are spot on, I cant imagine how they need improving. No signs of over temperature or splatter and certainly no pin holes. Flanges are more than suitable for the task and give a perfect seal when bolted up. Fitment was perfect, your always going to get the odd one that may need the odd tweak. The amount of exhausts they sell theres always going to be a few that slip through.
To be honest my car is running just over 300 bhp so 3" is probably over kill, 2.5" would have been more suitable but 3" was easier to source.
To be honest my car is running just over 300 bhp so 3" is probably over kill, 2.5" would have been more suitable but 3" was easier to source.
Do cobra not make 2.5" then ? If you're running 3" on an unmapped car coming from 2.5" you have robbed yourself some torque 
saying 3" is easier to source than 2.5 " when you bought it from a custom exhaust manufacturer and supplier 
Thread
Thread Starter
Forum
Replies
Last Post
fatboy_coach
General Technical
15
18 June 2016 03:48 PM