Forced to break my 350bhp v3 sti :(
Yeah, really good, especially for an import. No bubbling whatsoever, as you can see on the one pic, there's very little surface rust under the car. Here's the other arch, again, really good for an import. The bits that look a tiny bit rusty, are just very slight surface rust where the bumper's rubbed. Nothing can be seen with the bumper on.
I need to add prices & pics, but here's a rough list that I have in my garage in Bournemouth:
Brake Servo
Master Cylinder & Resevoir
Brake Pipes
Header Tank
3 Port Boost Solenoid
Air con pump, pipework & rad
ABS Pump, relays, bracket etc
Starter motor
PAS Pump
Battery
Alernator
Clutch slave cylinder
Idle control valve
standars recirculating dump valve
Throttle body & Throttle position sensor
Coil & leads
Rad & fans
Orange label maf
standard airbox & flexi pipe
wiper motor
PAS cooling pipe
Rear disc drums with shoes @ pads (all less than 1000 miles old)
Rear calipers
Rear hubs, control arms, trailing arms etc
Front & rear sti struts
TY752VBCAA STI gearbox
matching r160 diff
propshaft
all driveshafts
Steering wheel
Gear ****
Handbrake
probably some more bits, but I'll need to check.
Also at my parents I have:
Standard arbs & rear droplinks
Standard sti exhaust including cat etc
Carbon Sti strut brace
newage wrx wheels & goodyear eagle f1 tyres, not the best, possible winter/ track use?
Brake Servo
Master Cylinder & Resevoir
Brake Pipes
Header Tank
3 Port Boost Solenoid
Air con pump, pipework & rad
ABS Pump, relays, bracket etc
Starter motor
PAS Pump
Battery
Alernator
Clutch slave cylinder
Idle control valve
standars recirculating dump valve
Throttle body & Throttle position sensor
Coil & leads
Rad & fans
Orange label maf
standard airbox & flexi pipe
wiper motor
PAS cooling pipe
Rear disc drums with shoes @ pads (all less than 1000 miles old)
Rear calipers
Rear hubs, control arms, trailing arms etc
Front & rear sti struts
TY752VBCAA STI gearbox
matching r160 diff
propshaft
all driveshafts
Steering wheel
Gear ****
Handbrake
probably some more bits, but I'll need to check.
Also at my parents I have:
Standard arbs & rear droplinks
Standard sti exhaust including cat etc
Carbon Sti strut brace
newage wrx wheels & goodyear eagle f1 tyres, not the best, possible winter/ track use?
To be honest, the tyres aren't great, leak on the beads a bit and only just legalon the tread depth. I was going touse them up on a wet trackday,but didn't get round to it. I'll get some photos in the next couple of days, but I'd let these go pretty cheaply.
For the rear diff & shafts, £100?
For the rear diff & shafts, £100?
Shell is now on ebay:
http://cgi.ebay.co.uk/ws/eBayISAPI.d...m=110830830478
the rest of the bits will be up during the next few days.
http://cgi.ebay.co.uk/ws/eBayISAPI.d...m=110830830478
the rest of the bits will be up during the next few days.
Updated List ;
17" wrx alloys & tyres, currently being held for buyer
currently avaliable:
Brake Servo. * * * * 10
Master Cylinder & Resevoir. * 10
Standard Alloy Header Tank. * * * 10
3 Port Boost Solenoid 20
2 port boost Solenoid * *20
Air con pump, * 25
pipework *10
& rad 10
ABS Pump, relays, bracket etc 10
Starter motor 15
PAS Pump 30
Alernator 15
Clutch slave cylinder 10
Idle control valve. *25
Standard* recirculating dump valve. *10
Throttle body & Throttle position sensor. *15
Coil & leads. 10
Rad & fans 25
standard airbox & flexi pipe 10
Front wiper motor 10
PAS cooling pipe 10
Rear disc drums with shoes @ pads (all less than 1000 miles old) 40
Rear * *15 each
Rear hubs, control arms, trailing arms etc * 20 each side
Front & rear sti struts *80
TY752VBCAA STI gearbox 150
propshaft 10
Front driveshafts 15 each
Steering wheel. * 15
Gear ****. *10
Handbrake. *10
Standard sti arbs 20mm & 21mm * * * * 15 each
Standard sti exhaust including cat etc. 50
Carbon Sti strut brace. 50
17" wrx alloys & tyres, currently being held for buyer
currently avaliable:
Brake Servo. * * * * 10
Master Cylinder & Resevoir. * 10
Standard Alloy Header Tank. * * * 10
3 Port Boost Solenoid 20
2 port boost Solenoid * *20
Air con pump, * 25
pipework *10
& rad 10
ABS Pump, relays, bracket etc 10
Starter motor 15
PAS Pump 30
Alernator 15
Clutch slave cylinder 10
Idle control valve. *25
Standard* recirculating dump valve. *10
Throttle body & Throttle position sensor. *15
Coil & leads. 10
Rad & fans 25
standard airbox & flexi pipe 10
Front wiper motor 10
PAS cooling pipe 10
Rear disc drums with shoes @ pads (all less than 1000 miles old) 40
Rear * *15 each
Rear hubs, control arms, trailing arms etc * 20 each side
Front & rear sti struts *80
TY752VBCAA STI gearbox 150
propshaft 10
Front driveshafts 15 each
Steering wheel. * 15
Gear ****. *10
Handbrake. *10
Standard sti arbs 20mm & 21mm * * * * 15 each
Standard sti exhaust including cat etc. 50
Carbon Sti strut brace. 50
Shell ends tomorrow afternoon, currently at £102!!!
http://cgi.ebay.co.uk/ws/eBayISAPI.d...m=110830830478
http://cgi.ebay.co.uk/ws/eBayISAPI.d...m=110830830478
ill have the STI front strut brace, also do you happen to have the prop shaft nuts and bolts as i have lost mine it seems
oh and the engine and gearbox mounts too if possible oh and fuel rails perhaps
oh and the engine and gearbox mounts too if possible oh and fuel rails perhaps
Hi Ginge, I think the bits you require are in the bin I'm afraid, and about 2 hours before you posted, I received a pm about the strut brace! I'll get back to him now, but if he doesn't want it I'll hold it for you.
The winning ebay bidder didn't contact me about the shell, so I've second chance offered it, otherwise its back up for sale!
Also no news from the buyer of the wrx 17" alloys & tyres, so they're back for sale, £70 cash if collected. I'll put upsome pics if there's any interest.
The winning ebay bidder didn't contact me about the shell, so I've second chance offered it, otherwise its back up for sale!
Also no news from the buyer of the wrx 17" alloys & tyres, so they're back for sale, £70 cash if collected. I'll put upsome pics if there's any interest.












