When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
ye he would just love that - airbag going off and shooting guage into his face
The airbag comes out of the top of the a pillar, the trim stays in place. The gauge will not be flying anywhere. This has been done to death on the US forums with pics etc after the bags have deployed. I'd happily fit one on the a pillar if there was a decent RHD mount.
Been looking at the omori myself from J Spec in the US, very nice
Plus all the usual extras.
You will need two clips P/N # 9091400063 to fit it and because we have an alarm bonnet switch it needs slight modification to fit.
Thought the battery cover aswell would be too much (it also needs modifying to fit the WRX)
As the cover uses the hole where the EGT connector sits I made a small aluminium bracket up to attach the connector and fitted it to the power steering pipes bracket.
Last edited by Don Clark; Sep 26, 2011 at 04:46 PM.
How do you get it clean, mine still has that slug juice on it.
Have you had your painted again Don or just cleaned it ? just the main red bit that you aint changed
I use Chemical Guys Heavy Duty Orange Degreaser, diluted, sprayed on and worked in using a small brush and then rinse off.
Takes two or three attempts to shift the stuff.
The Red inlet manifold is original and has been difficult to get clean.
Still has some ingrained dirt on it.
It doesn't appear to be as bright a red as I remember STi manifolds.
It stays clean like the rest of the car, picture here at Snetterton yesterday........
Last edited by Don Clark; Feb 3, 2020 at 06:49 PM.
HT Auto rear diffuser fitted, added some rubber edging to it where it meets the bumper ...............
It ends about half way along the wheel well, so decided to add an extension piece to take it almost up to the subframe and mounted using some existing holes (plus a couple of self tappers) in the wheel well stiffening..........
Used part of a plastic mixing tray cut to size and then covered it in heatshield tape as its above parts of the exhaust "Y" pipe..........
Last edited by Don Clark; Feb 3, 2020 at 06:53 PM.
Just completed the JDM auto folding mirrors on locking installation
Mirror folding button on dash panel still performs as normal.(and still not illuminated Tony )
Mirrors fold on locking car using either door button or alarm fob.
Mirrors unfold AFTER unlocking car and pressing start button to ACC position.
As UK cars have double locking system, trigger feed to fold then is slightly different to the supplied instructions.
(still yellow) or do you mean the STi header tank rad cap ? 
don't need to put oil in the water a UK will do that by it'self 
