1994 subaru turbo missfire please help tried everything
05 February 2011, 03:17 PM
#122
Scooby Regular
Join Date: Jan 2011
Posts: 57
Likes: 0
Received 0 Likes
on
0 Posts
Right timing done and sorted now my scooby runs like a dream when its cold but as soon as it reaches operating temp the misfire comes back!!!!!!!!!!!!!!!!! I dont have a clue where to start.
06 February 2011, 12:02 PM
#123
Scooby Regular
Thread Starter
iTrader: (2)
Join Date: Dec 2010
Posts: 88
Likes: 0
Received 0 Likes
on
0 Posts
hello mate well i fitted the new pulley yesterday, took about 5 minutes to do, spent about an hour n half trying to time it up but the exhasut pulleys would always be a tooth out, i think its because its an aftermarket belt (dayco) so yesterday i ordered a gates 1 which someone on here recommended it will touch me door tomorrow morning, sorry to hear it mate was yours much out on the timing
06 February 2011, 03:13 PM
#124
Scooby Regular
Join Date: Jan 2011
Posts: 57
Likes: 0
Received 0 Likes
on
0 Posts
Yes it was about 1 tooth out!!! If the misfire starts and I change the cam sensor the misfire goes away but after a while comes back seems like its when the sensor heats up it doesnt send the right signal. The weird thing is I have 2 sensors here and they both do the same thing!
06 February 2011, 03:36 PM
#128
Scooby Regular
Join Date: Jan 2011
Posts: 57
Likes: 0
Received 0 Likes
on
0 Posts
Hey Musso On my ECU I have a common sield wire for the Cam sensor and crank sensor in other words I have 1 shield wire going in to the ECU and not 2! The cam and crank sensor wires are in one loom with one shield around them! My question: is this normal or should it have 2 individual looms each with its own shield? I am wondering if the 2 signal wires cant interfere with each other as they are in one loom!!!!!!! Really doesnt make sense why it will run fine for a while and then start with the misfire...... Is there a way to test the cam sensor???????
18 February 2011, 09:48 PM
#129
Scooby Regular
Thread Starter
iTrader: (2)
Join Date: Dec 2010
Posts: 88
Likes: 0
Received 0 Likes
on
0 Posts
set the timing to spot on literally dead in line but it seems to of made the problem worse surely it should of made it better ive checked it several times to make sure ive done it right and the marks are spot on.
Thread
Thread Starter
Forum
Replies
Last Post
blockhead
Subaru Parts
19
07 November 2015 11:50 PM
MH-Racing
Subaru Parts
18
18 October 2015 04:49 PM
Danny0608
Subaru Parts
0
12 September 2015 02:59 PM
