Bttt:///

 

how easy are the act guages to fit? i have one of your hybrid front mounts

 

Desided to delete bov Harvey pm or email me and I'll sort £££

 

Do you have FMIC or TMIC?

ACT guage is an easy job.
Brass temp sender is located prior to the throttle body. I usually use an insert sleeve into which I tap the sender.

 

Yeah it's Mick Harvey Fmic we have talked via email now pal

 

do you have any pics of how you have fitted them harvey at all?

 

You should already have one connected to the syvecs, will show you how to view the temp with the laptop next time you come down

 

o ok cheers banny

 

ACT guage fitted to STi 3 Wagon.


The ACT guage probe is green with a brass hex sender. This is tapped in to the Hybrid FMIC hard pipe a short distance before the throttle body. The black cable is the temperature sender for the Simtek ECU also tapped in to the hard pipe just before the throttle body.


Close up of the probe. Also in the picture is the high pressure pump and reservoir for the water methanol injection.


ACT guage fitted to turbo diesel.



The ACT probe is green and inserted in the cold air pressure feed from a Hybrid front mount intercooler mounted discreetly on a 1.9 Vauxhall Vectra CDTi/SRi Turbo Diesel. Currently 282 bhp and 388 ft. lbs.

 

ACT guage = £87.50 posted.

 

bttt.///

 

bttt.///

 

I need one of the adapters for a newage BOV to go on the japspeed FMIC please. been looking all over for them

YOU HAVE PM.

 

What's the refresh rate like on the ACT gauge?

 

I do not know for sure but it must refresh deveral time per second.
I have never had issues with the speed of refresh but getting the right location is important. Drilling and taping into the inlet manifold for instance and readings are influenced by manifold temp. Best location is in a sleeve close to the throttlebody.
I can give you more detail if you need it but it is easy to install and neat.

 

bttt.///

 

bttt.///

 

bttt.///

 

bttt.///

 

YHPM

 

See your PMs and let me have more info please.

 

Info required is
The make of IC is a HDI GT SPEC2, the pipe I'm after is the first one from IC to wing if you could help please let me know cost complete with postage and payment details.I have paypal can can pay as gift as I try and treat people as I would want to be treated many thanks,
Ivan.
Info also sent in a PM many thanks.

 

Hi did you manage to have a look see if you have the pipe I was after cheers

 

Yes, you will have had my email yesterday. In stock

 

Harvey, can you please assist I'm looking to source some 60-75mm and 70-90mm heavy duty hose clamps and a 63-51mm ID S shaped intercooler hose.

 

Clamps I probably have and will respond tea time.
How many of each.
What is the hose? Where does it run. Most Hybrid stuff is 63 diameter. Only 2" is off the compressor outlet???

 

The hose is 51mm / 2" from the compressor outlet but the pipework is 63mm, and it is slightly S shaped.

With reference to the clamps I need 6 of each, I would prefer the following type if you can supply.

 

Clamps of that design I do not have but I do have the "S" Pipe.
I will send photos to your e-mail address per profile this evening.

 

bttt.///

 

Do you still have the BOV adaptors for a bugeye FMIC matey?