what is the current spec simon?

 

SimTek ecu
650cc injectors
hybrid fmic
MD321T
k&n cone and ally spun trumpet
silicone intake pipe
3inch decat
3bolt tubular headers
Standard Sti engine

Simon

 

The Stealth Wagon.

 

Flat eric Mark ,where id you get that lowe grill.

 

what do you think mine will make?
simtek
800cc pe
hybrid fm
fp green
ap intake 3"
3" decat japspeed
rcm inlet
255 pump
std headers
parallel fuel rail
standard sti engine

 

Upper & lower are both home made. Stainless mesh from Halfords spot welded to stainless rod for the surround.

Can be had for much wonga from Subaru as a genuine accessory (Part No. SECSSE3060) or from here Zunsport Impreza Blob Eye Car Grilles

 

 

the FP greens are a bit difficult to judge, they never seem to be the same spec

 

Very nice car,love that colour

 

My MY05 JDM STi winning the standard class at scoobysprint.

 

Flat Eric......that is one nice Wagon you got there.

 

Thanks Mark ,i think i will have a go at the diy as ive been on the verge of making one for a while just havent found a mesh patten i like but yours is ideal.I'm off to halfords tomorrow for a look.

The car looks superb by the way.

 

Thanks m8

 

Have you suddenly bought a new car jag

 

Not had the car long, so the pictures are lacking quality back drops and the door was left open

But the sti stickers on the flaps and wing have now gone and the PPP rear silencer is now back on too.

 

rough estimate? then

 

380~450 depending on whcih one it is..

they are not wonderful compared to other turbos tbh with regard to spool and throttle response

Simon

 

No, but I'd bloody like to as I cannot remember what it looks like! That said, the Forrester I've got now is not slow by any means!

 

The two different runs ?

Different boost ?

What was the boost needed to hit 450 ?

 

lower is on 2.5inch exhaust, higher on 3inch exhaust.

1.7bar peak, holding 1.6bar.. I was going to run more if needed but was just aiming for 450 at the time.

Simon

 

 

For a second I thought you were using my log on!! Nice scoob btw

 

Thanks mate

yea, they are similar too!

 

Just sold mine last week.

 

Very nice too, looks clean, you must be sad to see it go?

 

Lush in red.

 

Thanks guys.

The Stealth Wagon won "Best of Show" on the SIDC stand at the Snetterton Modified Live/Time Attack Final Round in 2008 & was featured on the old Wolfrace website some time ago.

There are more pictures & it's spec in "My Garage"

wayner845 you will need some good quality sharp wire cutters when you trim the mesh as it's quite tough. Long handles for leverage will help as well.

 

Not many blobs on show so here is mine, Had her since new, Constantly evolving. 429bhp 390lbft torque. with 10% Meth. Standard bottom end mapped by Paul at Zen

md321t turbo
650cc injectors
milltek 3" decat
Hybrid FMIC
K+N induction
Ecutek map

 

Separated at birth?



Steve

 

if i knew how to move pics from my garage to here i would .Unless somebody can tell me how?