Perfection
#152
Also a huge thanks to Paul @ Zen for the inlet manifold which will allow me to run v5/6 heads with v1 inlet manifold and set up/management etc
Which is in the pile of bits to be sprayed
Simon[/QUOTE]
Is it a hybrid of the two versions and reversed?
Mark
Which is in the pile of bits to be sprayed
Simon[/QUOTE]
Is it a hybrid of the two versions and reversed?
Mark
#153
Former Sponsor
Thread Starter
iTrader: (4)
Join Date: Jan 2001
Location: ECU Mapping - www.JollyGreenMonster.co.uk
Posts: 16,548
Likes: 0
Received 2 Likes
on
2 Posts
sort of..
it is a v1 manifold widenned and front entried to fit the width and then there is spacers that adapt to the bolt holes on the heads with heat spacers between.
Simon
it is a v1 manifold widenned and front entried to fit the width and then there is spacers that adapt to the bolt holes on the heads with heat spacers between.
Simon
#157
Former Sponsor
Thread Starter
iTrader: (4)
Join Date: Jan 2001
Location: ECU Mapping - www.JollyGreenMonster.co.uk
Posts: 16,548
Likes: 0
Received 2 Likes
on
2 Posts
Thanks guys.. next priority is rear bulk head as not keen on that fuel behind the spongy seat!!!
Might have to upgrade the fuel hose used for fuel pump and siwrl pot too as it leaks a little fume when tuned off.. so smell of petrol when returning to the car.. seen and been in far worse mind you. Rear bulk head sealed nicely might help.
Simon
Might have to upgrade the fuel hose used for fuel pump and siwrl pot too as it leaks a little fume when tuned off.. so smell of petrol when returning to the car.. seen and been in far worse mind you. Rear bulk head sealed nicely might help.
Simon
#158
#163
Former Sponsor
Thread Starter
iTrader: (4)
Join Date: Jan 2001
Location: ECU Mapping - www.JollyGreenMonster.co.uk
Posts: 16,548
Likes: 0
Received 2 Likes
on
2 Posts
posting the pic of the swirl pot and pump yesterday I then noticed the state of the wiring.. tidied it up and then looking at this pic I see I need to remove some more of the tar sound proofing from the boot
Simon
Simon
#164
What gauge wire have you got running to the pump Simon?
Looks thicker than mine, I might need to upgrade looking at yours.
Oh and youll get use to the fumes after a while.
Looks thicker than mine, I might need to upgrade looking at yours.
Oh and youll get use to the fumes after a while.
#165
Former Sponsor
Thread Starter
iTrader: (4)
Join Date: Jan 2001
Location: ECU Mapping - www.JollyGreenMonster.co.uk
Posts: 16,548
Likes: 0
Received 2 Likes
on
2 Posts
Fumes and your car doesnt explain it enough!
It removed my eyebrows and skin from my throught lol.
Not sure I bought an amp wiring kit from halfords.
It is overkill tbh but could run two pumps off it in the future
It removed my eyebrows and skin from my throught lol.
Not sure I bought an amp wiring kit from halfords.
It is overkill tbh but could run two pumps off it in the future
#170
Former Sponsor
Thread Starter
iTrader: (4)
Join Date: Jan 2001
Location: ECU Mapping - www.JollyGreenMonster.co.uk
Posts: 16,548
Likes: 0
Received 2 Likes
on
2 Posts
thanks.. headlight washers were removed and holes filled before spraying etc..
Planning to pic up fog covers this week..
I prefer the standard 00 headlights.. but need a manual drivers side one to replace the leccy adjust one I have already.
Simon
Planning to pic up fog covers this week..
I prefer the standard 00 headlights.. but need a manual drivers side one to replace the leccy adjust one I have already.
Simon
#172
Scooby Senior
iTrader: (3)
Join Date: Jun 2006
Location: Slowly rebuilding the kit of bits into a car...
Posts: 14,333
Likes: 0
Received 0 Likes
on
0 Posts
Slit conduit will tidy up your wiring nicely !
Good work, and nice project Mr. JGM.
Mine's in the bodyshop all week !
dunx
Good work, and nice project Mr. JGM.
Mine's in the bodyshop all week !
dunx
Last edited by dunx; 14 February 2009 at 08:22 PM.
#173
Former Sponsor
Thread Starter
iTrader: (4)
Join Date: Jan 2001
Location: ECU Mapping - www.JollyGreenMonster.co.uk
Posts: 16,548
Likes: 0
Received 2 Likes
on
2 Posts
picked up some new front fog covers whilst mapping at scoobyworld
will fit cold air feed and paint covers in time
repaired flock on the dash
before
after
no before on passenger side but it was as bad as drivers
Also bought some box speakers intending to remove all four original and fit the two box ones to cage.. but they were heavier than the four original so I have removed the front speakers..
Simon
will fit cold air feed and paint covers in time
repaired flock on the dash
before
after
no before on passenger side but it was as bad as drivers
Also bought some box speakers intending to remove all four original and fit the two box ones to cage.. but they were heavier than the four original so I have removed the front speakers..
Simon
#175
Former Sponsor
Thread Starter
iTrader: (4)
Join Date: Jan 2001
Location: ECU Mapping - www.JollyGreenMonster.co.uk
Posts: 16,548
Likes: 0
Received 2 Likes
on
2 Posts
I got stopped a couple of months back and £30 fine for plates.. they now inform dvla and dvla write to you.. after so many times they take the number plate off you and you get a Q plate.
it has been in the front screen the past too weeks as I didn't want to fit it but decided today that I best do so.. it looks pants
May go for a legal square one..
Simon
it has been in the front screen the past too weeks as I didn't want to fit it but decided today that I best do so.. it looks pants
May go for a legal square one..
Simon
#179
Former Sponsor
Thread Starter
iTrader: (4)
Join Date: Jan 2001
Location: ECU Mapping - www.JollyGreenMonster.co.uk
Posts: 16,548
Likes: 0
Received 2 Likes
on
2 Posts
cable ties?
I had assumed Stevens colourist () cable tie comment was about the green and red on the fuel system?
I used up the last of my black ones securing the alarm sensors and wiring to the cage
I had assumed Stevens colourist () cable tie comment was about the green and red on the fuel system?
I used up the last of my black ones securing the alarm sensors and wiring to the cage
#180
Scooby Regular
iTrader: (55)
I got stopped a couple of months back and £30 fine for plates.. they now inform dvla and dvla write to you.. after so many times they take the number plate off you and you get a Q plate.
it has been in the front screen the past too weeks as I didn't want to fit it but decided today that I best do so.. it looks pants
May go for a legal square one..
Simon
it has been in the front screen the past too weeks as I didn't want to fit it but decided today that I best do so.. it looks pants
May go for a legal square one..
Simon
Square is the answer Simon, here's mine-