Later MAP sensor wiring.
#1
Later MAP sensor wiring.
Hi guys.
Will be fitting a MY98 MAP sensor to my MY93 so I can run 1.2 bar boost without hitting fuel cut.
Assuming I am holding the new sensor with the boost/vacuum pipe pointing down wards which is the power/ground and sensor pins. Unfortunately I did not get a plug with it so will be soldering direct to the pins.
Thank you in advance.
Cheers. Mark.
Will be fitting a MY98 MAP sensor to my MY93 so I can run 1.2 bar boost without hitting fuel cut.
Assuming I am holding the new sensor with the boost/vacuum pipe pointing down wards which is the power/ground and sensor pins. Unfortunately I did not get a plug with it so will be soldering direct to the pins.
Thank you in advance.
Cheers. Mark.
#2
Scooby Regular
Join Date: Dec 1999
Location: Aberdeen
Posts: 658
Likes: 0
Received 0 Likes
on
0 Posts
With the pipe facing down as you said
signal is in middle - connect to white wire
Bottom is power - connect to red
Top is earth - connect to green
Last edited by Ken Ross; 26 May 2006 at 01:00 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM