Later MAP sensor wiring.
Hi guys.
Will be fitting a MY98 MAP sensor to my MY93 so I can run 1.2 bar boost without hitting fuel cut. Assuming I am holding the new sensor with the boost/vacuum pipe pointing down wards which is the power/ground and sensor pins. Unfortunately I did not get a plug with it so will be soldering direct to the pins. Thank you in advance. Cheers. Mark. |
http://www.ken555.plus.com/carl/map.jpg
With the pipe facing down as you said signal is in middle - connect to white wire Bottom is power - connect to red Top is earth - connect to green |
All times are GMT +1. The time now is 06:23 PM. |
© 2024 MH Sub I, LLC dba Internet Brands