ABS Light Problems
Hi Guys,
I have a Bugeye Impreza WRX STI Type UK which has had an 8 pot break conversion on the front, When I got the car the lad said the light had been on since then.
Thing is I have checked the ABS sensors and they are fine, Fluid is fine. ABS defo not working when I break hard in wet.
What else could it be any faults that are common to these cars.
Any help greatly appreciated Guys
Dex
I have a Bugeye Impreza WRX STI Type UK which has had an 8 pot break conversion on the front, When I got the car the lad said the light had been on since then.
Thing is I have checked the ABS sensors and they are fine, Fluid is fine. ABS defo not working when I break hard in wet.
What else could it be any faults that are common to these cars.
Any help greatly appreciated Guys
Dex
Hi,
Thanks for the info
Its in a garage now but they can connect any of the computer equipment to it, it connects fine with other STI card from classics to new age but mine wont connect.
I even purchased a meter off here one of the other guys used and it wont recognise my car.
So even if i get it to you guys will your diagnostic equipment connect.
How much for a diagnostic test mate ?
Regards
Dex
Thanks for the info
Its in a garage now but they can connect any of the computer equipment to it, it connects fine with other STI card from classics to new age but mine wont connect.
I even purchased a meter off here one of the other guys used and it wont recognise my car.
So even if i get it to you guys will your diagnostic equipment connect.
How much for a diagnostic test mate ?
Regards
Dex
depends on what equipment they are trying to use as some can be problematic, we have a Subaru "select monitor" so unless your car has an aftermarket ECU or some other issue then its not a problem.........
Trending Topics
Well guys
booked into AS Performace tomorrow to see if they can connect there diagnostics to my car, Think its caused by the Simtek ECU. Hopefully I will be able to see what the fault is.
Cheers Again
Dex
booked into AS Performace tomorrow to see if they can connect there diagnostics to my car, Think its caused by the Simtek ECU. Hopefully I will be able to see what the fault is.
Cheers Again
Dex
Last edited by t2dex; Mar 8, 2013 at 01:32 PM. Reason: Typo
many thanks to as performance top guy, for looking at my car today, spoke to enginetuner after you, he confirmed that the odbc port no longer functions after the simtek chip, said I would have to get an auto electricion to diagnose the abs. thanks guys again.
hi jay,
yeah get that now lol, not good when u have an abs fault though. as performance kinda figured it out then a call to alan jeffrey confirmed it, both top guys. then pulled up to my door and bloody no reverse gear, just won't go into reverse, hope its just cable as as performance mentioned in my other post, snowing here so too cold to check,
thanks guys
yeah get that now lol, not good when u have an abs fault though. as performance kinda figured it out then a call to alan jeffrey confirmed it, both top guys. then pulled up to my door and bloody no reverse gear, just won't go into reverse, hope its just cable as as performance mentioned in my other post, snowing here so too cold to check,
thanks guys
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
Dec 28, 2015 11:07 PM





