Geomerty setup how much??
Scooby Regular
Joined: May 2000
Posts: 10,371
Likes: 0
From: MY00,MY01,RX-8, Alfa 147 & Focus ST :-)
Jamie
The website for Powerstation is here
For the record I paid £160 at Powerstation to have my Eibach's fitted and the alignment / geometry setup, so £60 to get just the geometry done sounds about right.
Cheers
Chris
(Edited to say that it looks like their website is down at the moment)
[Edited by Chris L - 4/30/2002 6:56:46 PM]
The website for Powerstation is here
For the record I paid £160 at Powerstation to have my Eibach's fitted and the alignment / geometry setup, so £60 to get just the geometry done sounds about right.
Cheers
Chris
(Edited to say that it looks like their website is down at the moment)
[Edited by Chris L - 4/30/2002 6:56:46 PM]
Scooby Regular
Joined: Sep 2001
Posts: 115
Likes: 0
From: Aberdeen
Bit far for you to go but a comparison anyhow - I paid £35 quid all in to get mine done at Falkland Performance in Fife last week.
Did it while I waited - about an hour aswell, and very friendly to cap it all.
Duncan.
Oh, and edited to say, what a difference it made to the handling!
[Edited by Abzdon - 4/30/2002 8:30:49 PM]
Did it while I waited - about an hour aswell, and very friendly to cap it all.
Duncan.
Oh, and edited to say, what a difference it made to the handling!
[Edited by Abzdon - 4/30/2002 8:30:49 PM]
Trending Topics
Scooby Regular
Joined: Mar 2001
Posts: 311
Likes: 0
I had mine done at TSL - from memory it was £90-£100 inc VAT. Took a lot longer than an hour, probably closer to 3 (I'm sure they take longer just to give Paul more chance to sell you stuff 
)
It's transformed the car though - I'd recommend them without a doubt
Richard
)It's transformed the car though - I'd recommend them without a doubt
Richard
Scooby Regular
Joined: Mar 2002
Posts: 174
Likes: 0
Micheldever Tyres http://www.micheldever.co.uk
M3 Junction 8, about £45 (inc VAT) but you need to book in advance and be there for 8am on the day!
Power Engineering http://www.powerengineering.co.uk
Uxbridge, about £80 but that incluydes a full road test to ensure that it's right!
Mill Lane Engineering (Subaru Dealer) Basingstoke
About 30 minutes labour, but no good if you have a Japanese import!
These are all for geometery settings, personally I would only use Micheldever and Mill Lane again! They all did the same, but PE charged nearly double and kept me waiting for an hour and half before doing it, despite booking!
M3 Junction 8, about £45 (inc VAT) but you need to book in advance and be there for 8am on the day!
Power Engineering http://www.powerengineering.co.uk
Uxbridge, about £80 but that incluydes a full road test to ensure that it's right!
Mill Lane Engineering (Subaru Dealer) Basingstoke
About 30 minutes labour, but no good if you have a Japanese import!
These are all for geometery settings, personally I would only use Micheldever and Mill Lane again! They all did the same, but PE charged nearly double and kept me waiting for an hour and half before doing it, despite booking!
Thread
Thread Starter
Forum
Replies
Last Post
