Rotate or not? (STi7)
I don't measure when I do mine but try to swap each side over whenever I wash the car. I usually take the wheels off to clean them and do it when I put them back on.
Makes a bigger task of washing the car but so what.
It's more relevant to the general tread depth than the actual scrubbing at the edges.
I've already put an ALK on and 22mm front and rear Anti roll bars and handling is already much tighter/accurate on and out of the corners. This can drastically reduce the rate at which your outer tyre edges wear as well. Even more necessary now the car has gained so much weight.
Mike.
[Edited by Mike Tuckwood - 4/9/2002 11:57:31 AM]
Makes a bigger task of washing the car but so what.
It's more relevant to the general tread depth than the actual scrubbing at the edges.
I've already put an ALK on and 22mm front and rear Anti roll bars and handling is already much tighter/accurate on and out of the corners. This can drastically reduce the rate at which your outer tyre edges wear as well. Even more necessary now the car has gained so much weight.

Mike.
[Edited by Mike Tuckwood - 4/9/2002 11:57:31 AM]
Thread
Thread Starter
Forum
Replies
Last Post
Welloilbeefhooked
General Technical
0
Sep 11, 2015 06:49 PM



