guys i have been searching and searching and i need some pointers.

my rear pads and disks have seen better days so rather than replacing the standard setup i was thinking of up grading

i dont have loads of money to spend and i have an AP conversion on the front already. just two questions

so what can i do with the rear there must be a better set of disks and pads i can fit?
can i fit larger disks to the standard calipers?


steve

 

btt

 

no, but you can fit a larger rear kit to your car (presuming you have a P1 with the 266mm sliding rear brakes)

easiest is the conversion using the new-age WRX 2pot calipers and 290mm discs

alyn

 

thanks mate,

also what are a good performance disk and pad set up to replace the factory bits

steve