Hi all
Can anyone give me any advice on fitting 22b wheels with 235 40 17's on, to a 95WRX. I have fully adjustable strut tops with coil over tien shocks.

What is the maximum spacer I can use, I know they tyers will not fit inside the arches but there is no give in the suspension as its is set at the moment. And obviously there will be a quicker wear on the bearings, but are there any other considerations.

Thanks

Deane Lyons

 

Dean, there should be the offset on the inside of the alloy, also have you bought these yet as they cost 1k EACH!! and are not cheap to replace (also limited and take time to purchase new ones)
As for the bearings... id say no, there shouldnt be a problem with them, the reason the 22B alloys are so expensive is the fact that they are sooooo light your only down side is that your going to have to get your arches rolled to accommodate the new wheels, nice they may be but you may want to consider a cheaper and a less hassle alternative

Tony

 

ooops i will still give u a fiver a tyre !! and wht is a manater????

[This message has been edited by GialloEvoII (edited 10 October 2001).]

[This message has been edited by GialloEvoII (edited 10 October 2001).]