Bedding in EBC Greenstuff
10 February 2001, 03:55 AM
#1
Scooby Regular
Thread Starter
Join Date: Oct 2000
Posts: 428
Likes: 0
Received 0 Likes
on
0 Posts
Can anybody tell be the correct bedding in procedure for EBC greenstuff pads . I'm fitting them to a '91 2.2 legacy along with a new set of genuine subaru ventilated discs .
10 February 2001, 07:22 PM
#3
Scooby Regular
Join Date: May 2000
Posts: 384
Likes: 0
Received 0 Likes
on
0 Posts
Turbo,
I had EBC Greenstuff pads on my previous Scooby. The bedding in instructions were in the box. Just take it steady for the 1st hundred miles or so (progressive and varied braking, I think it said) in order not to glaze the pads and do not brake hard unless in an emergency.
Mine were crap at 1st but once bedded in they did work quite well on the road. Not too good on the track I hear, though.
Checkout the amount of brakedust from them hardly any at all
Scotty.
[This message has been edited by SCOTTY (edited 10 February 2001).]
I had EBC Greenstuff pads on my previous Scooby. The bedding in instructions were in the box. Just take it steady for the 1st hundred miles or so (progressive and varied braking, I think it said) in order not to glaze the pads and do not brake hard unless in an emergency.
Mine were crap at 1st but once bedded in they did work quite well on the road. Not too good on the track I hear, though.
Checkout the amount of brakedust from them hardly any at all
Scotty.
[This message has been edited by SCOTTY (edited 10 February 2001).]
Thread
Thread Starter
Forum
Replies
Last Post
