complete rear axle, and prop shaft
#1
Scooby Newbie
Thread Starter
Join Date: Feb 2007
Location: Fife, Scotland
Posts: 14
Likes: 0
Received 0 Likes
on
0 Posts
complete rear axle, and prop shaft
i recently broke my fwd 1.6 impreza, so after replacing it with a beemer i set about converting it for play use. i have a 3.5 rover v8 and i'l be collecting a gearbox to suit soon.
my intention is to use a rear axle, suspension setup from a 4x4 and a 2wd gearbox mated to the v8. for rwd fun.
i'm going to have the money to buy all the bits early april so i thought i'd join here and see if i could put some money into any of your pockets.
on the wanted list is
(1) rear axle, with driveshafts, hubs, disc brakes, and suspension (although i was looking into coilovers so i can even the height out and ajust damping ect ect.)
(2) rear part of the propshaft
and if anyone else happens too be a rover fan too, i'm looking for a LT77 box with the RV8 bellhousing and front part of the prop
sorry for sutch a brief description. i'm about to be late for work. i'l try and post in the newbies section later with a few photos
George
my intention is to use a rear axle, suspension setup from a 4x4 and a 2wd gearbox mated to the v8. for rwd fun.
i'm going to have the money to buy all the bits early april so i thought i'd join here and see if i could put some money into any of your pockets.
on the wanted list is
(1) rear axle, with driveshafts, hubs, disc brakes, and suspension (although i was looking into coilovers so i can even the height out and ajust damping ect ect.)
(2) rear part of the propshaft
and if anyone else happens too be a rover fan too, i'm looking for a LT77 box with the RV8 bellhousing and front part of the prop
sorry for sutch a brief description. i'm about to be late for work. i'l try and post in the newbies section later with a few photos
George
#3
Scooby Newbie
Thread Starter
Join Date: Feb 2007
Location: Fife, Scotland
Posts: 14
Likes: 0
Received 0 Likes
on
0 Posts
yes!
i'm in scotland tho!
i can get a trailer. but i wont have the cash till early april. if this still sounds ok to you. i'l get back in touch nearer the time.
firstly where are you? and do you have a price in mind?
i'm in scotland tho!
i can get a trailer. but i wont have the cash till early april. if this still sounds ok to you. i'l get back in touch nearer the time.
firstly where are you? and do you have a price in mind?
#4
hi,,, my cousin has asubaru impreza estate 1.6gl - L-reg ,silver looks nice,,,no tax or test ,,, but it has a lever inside to make it 2 or 4 wheel drive ,,,
he wants £500 for whole car is this any good to you ,,needs a quick sale thou...
thx sparky
he wants £500 for whole car is this any good to you ,,needs a quick sale thou...
thx sparky
#5
Scooby Newbie
Thread Starter
Join Date: Feb 2007
Location: Fife, Scotland
Posts: 14
Likes: 0
Received 0 Likes
on
0 Posts
sparky a whole car would be good but i'm needing all the better performing bits from a turbo model
a turbo is puting out a wee bit over 200 hourse through all 4 wheels. and to start with my v8 will prob put out slightly under 200bhp but only through the one diff. so i need it to be a good one i'm afraid.
will have the cash to spend next month so i'l check back with k18llr then or re-post if he's sold his bits
you can tell your cousin i have a good spare engine here if he / his buyer wants it. i was planning on using it in a dirt bugy some time in the future. but i'd rather get on with the main project so the engine can sell if the right moneys offered. also all the loom and ecu - everything it needs to run infact
George
a turbo is puting out a wee bit over 200 hourse through all 4 wheels. and to start with my v8 will prob put out slightly under 200bhp but only through the one diff. so i need it to be a good one i'm afraid.
will have the cash to spend next month so i'l check back with k18llr then or re-post if he's sold his bits
you can tell your cousin i have a good spare engine here if he / his buyer wants it. i was planning on using it in a dirt bugy some time in the future. but i'd rather get on with the main project so the engine can sell if the right moneys offered. also all the loom and ecu - everything it needs to run infact
George
#7
Scooby Newbie
Thread Starter
Join Date: Feb 2007
Location: Fife, Scotland
Posts: 14
Likes: 0
Received 0 Likes
on
0 Posts
anything else you know of from the rear?
as said, i'l have the cash next month. pm me a price for what you got.
i'm up in scotland but i will probably be down at newcastle next month too. where r you?
George
Last edited by v8scooby; 05 March 2007 at 08:28 PM. Reason: mistake correction
Trending Topics
#11
Scooby Newbie
Thread Starter
Join Date: Feb 2007
Location: Fife, Scotland
Posts: 14
Likes: 0
Received 0 Likes
on
0 Posts
BTT
i have some cash now but not alot.
i need
rear subframe
rear dif and shafts
rear hubs, with brakes
rear part of propshaft
all for a 94 model
i'm in central scotland, so the closer the better!
and the cheeper the better.
off work next week to strip / collect
Cheers George
i have some cash now but not alot.
i need
rear subframe
rear dif and shafts
rear hubs, with brakes
rear part of propshaft
all for a 94 model
i'm in central scotland, so the closer the better!
and the cheeper the better.
off work next week to strip / collect
Cheers George
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
Scott@ScoobySpares
Full Cars Breaking For Spares
55
05 August 2018 07:02 AM
Mattybr5@MB Developments
Full Cars Breaking For Spares
38
17 July 2016 10:43 PM
Scott@ScoobySpares
Full Cars Breaking For Spares
7
14 December 2015 08:16 AM