Any of your old Maf sensors required as pissed off with blowing these , now doing research into what blows them, underdstand its not the MAFs themselves that are causing the problem, but another underlying problem.

Have a circuit board electrician on the case and need a few to work on to find out if these can be repaired or a preventable soloution in stopping them blowing.

Asking for the goodwill of Scoobynet to send them to me by the cheapest postage possibly rather than bin them.

Just send me a PM for my address if you are willing to send one

Thanks all

Big Daz

 

What air filter do you have?

I've just replaced mine so you can have the old one. PM me where to post and I'll send it ASAP.

 

Thanks mate PM sent

I did have a HKS mushroom filter but have now gone back to the standard airbox and pipercross panel filter.

Daz

 

Wont the oil on the piper cross kill the maf sensor?

 

subaru recomend pipercross panel filters not sure what else do you suggest im def going for standard air box but could go for kn or something.

 

sti panel filter?

 

yea i might try a sti one and see

 

The MY99-00 are that sensitive I'd make sure you stick with the airbox and a dry filter.

 

I've read of filter oil (excessive) and vibration (unsecured CAIs etc.) quoted as reasons for failure.

J.

 

ive also been told heat is a posible cause so im looking into that anymore ideas.

 

daz,

i've been running the STI panel filter with no probs at all. Still got my old one (with a bit of life left in it) if you want it

 

thanks rob ill give that a try ill give you a call.

 

up for yer Daz