Exhaust
#1
Scooby Newbie
Thread Starter
Join Date: Feb 2012
Location: West London
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
Exhaust
Three section exhaust taken off my son's 52 plate WRX STI Prodrive. This exhaust does not have a Catalyser. It was removed to be replaced by full JANSPEED system with a Cat.
The first section has a small hole near to the flexi section where I believe a Cat/Lambda sensor was mounted, which most likely came off when the system was removed. The middle section is 100% fine. The rear box of the final ection had to have its support lug re-attached to it, but is abolutely fine otherwise.
I E-bayed this yonks ago, but only had scant interest. I am happy to offer the whole lot for £50, and will deliver to a 50 mile radius from home for £10. I'd rather this lot went to a good home than my local scrap metal dealers.
Photos: (Click on 'em to bring them up)
Mike
The first section has a small hole near to the flexi section where I believe a Cat/Lambda sensor was mounted, which most likely came off when the system was removed. The middle section is 100% fine. The rear box of the final ection had to have its support lug re-attached to it, but is abolutely fine otherwise.
I E-bayed this yonks ago, but only had scant interest. I am happy to offer the whole lot for £50, and will deliver to a 50 mile radius from home for £10. I'd rather this lot went to a good home than my local scrap metal dealers.
Photos: (Click on 'em to bring them up)
Mike
Thread
Thread Starter
Forum
Replies
Last Post
fatboy_coach
General Technical
15
18 June 2016 03:48 PM