Just a quick one. Im changing my standard v3 mid level spoiler for an Original P1 spoiler. Will all the holes line up or will i have to get the drill out ??

 

Pretty sure they line up.

Some people put a few more screws through the bootlid in the centre, or you could use TigerSeal.

 

the p1 spoiler has 10 holes, the mid level has 6 im pretty sure.

the bootlid will need to be drilled to fit the inner 4 holes, easy task though or the bolts on the p1 spoiler can be slid out and removed without damaging it.

 

Thanks for advice. I was hoping not to drill but never mind i think it will be worth it.

 

its easy mate. place the p1 bottom part over the boot lid, the end fixings are the same, lightly press it down. you will know see all the marks where you need to drill

that it.

 

Nice1

 

Or you can remove the inner bolts. They slide out and use double sided sticky tape for the centre section