advice on having rear bumper corner splitters sprayed on classic
#1
Scooby Regular
Thread Starter
iTrader: (5)
Join Date: Mar 2008
Posts: 795
Likes: 0
Received 0 Likes
on
0 Posts
advice on having rear bumper corner splitters sprayed on classic
would a good sprayer be able to respray the rear bumper corners splitters on my classic still fitted? i have some replacement ones off a bumper that was given me which i was going to swap the splitters over but after trying to remove them it was virtually impossible so im now thinking would it be easier to get them sprayed on the car?
#2
Scooby Regular
iTrader: (2)
Join Date: Jan 2007
Location: l'on n'y peut rien
Posts: 2,922
Likes: 0
Received 0 Likes
on
0 Posts
Yes, they can be sprayed in place, but get a GOOD bodyshop on it or it'll end in tears.
Removal of the old ones is by undoing a clip below the rear of the spat, a bolt near the front, then grasp the spat and pull it HARD towards the rear of the car. It slides off, believe it or not.
Removal of the old ones is by undoing a clip below the rear of the spat, a bolt near the front, then grasp the spat and pull it HARD towards the rear of the car. It slides off, believe it or not.
#3
Scooby Regular
Thread Starter
iTrader: (5)
Join Date: Mar 2008
Posts: 795
Likes: 0
Received 0 Likes
on
0 Posts
the bumper i was given has good condition rear corner splitters on it so my intentions was to swap these with the worn ones already on my car, i removed them but there so hard to get off as the brackets are all rusted & dont slide at all & this was with the doner bumper so would be alot harder i imagine to get the ones off the car
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
Scott@ScoobySpares
Full Cars Breaking For Spares
7
14 December 2015 08:16 AM
Mattybr5@MB Developments
Full Cars Breaking For Spares
20
22 October 2015 06:12 AM