Problem With Sigma Alarm
12 November 2007, 09:07 AM
#1
Scooby Newbie
Thread Starter
Join Date: Nov 2007
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Problem With Sigma Alarm
Been searching for ages for help with a Sigma Alarm and this site keeps popping up so hope someone can help.
I recently changed the car battery and now the alarm goes off every time i open the doors. The cars second hand and i dont have the alarm code to enter into the key pad. The Sigma instruction booklet had the alarm model as either an M12 or M30 I think.
I recently changed the car battery and now the alarm goes off every time i open the doors. The cars second hand and i dont have the alarm code to enter into the key pad. The Sigma instruction booklet had the alarm model as either an M12 or M30 I think.
14 November 2007, 11:17 AM
#2
Scooby Newbie
Join Date: Feb 2007
Posts: 14
Likes: 0
Received 0 Likes
on
0 Posts
Suspect that this is an M12 alarm and that you are using the vehicle's existing remotes to both unlock the car and disarm the alarm - non Subaru.
Disconnect the battery again, reconnect and then operate the vehicle's remote to Lock, Unlock, Lock and then Unlock. The M12 alarm system will then re-learn the arm and disarm inputs.
Disconnect the battery again, reconnect and then operate the vehicle's remote to Lock, Unlock, Lock and then Unlock. The M12 alarm system will then re-learn the arm and disarm inputs.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM
toyney83
General Technical
10
02 October 2015 08:38 PM