SIGMA M30 - Door open chirps not ON
23 April 2007, 09:02 PM
#1
Scooby Regular
Thread Starter
Join Date: Feb 2001
Posts: 364
Likes: 0
Received 0 Likes
on
0 Posts
SIGMA M30 - Door open chirps not ON
MY99 Wagon
Have downloaded the re-programming instructions which state that after fully arming system you should then disarm and enter programming code into keypad - each No. being confirmed with a single led flash from keypad. I have tried and tried but no joy - the LED flashes a few times at me every time I try entering digits. What am I doing wrong???
Help very much appreciated.
Have downloaded the re-programming instructions which state that after fully arming system you should then disarm and enter programming code into keypad - each No. being confirmed with a single led flash from keypad. I have tried and tried but no joy - the LED flashes a few times at me every time I try entering digits. What am I doing wrong???
Help very much appreciated.
25 April 2007, 11:15 AM
#2
Scooby Regular
Join Date: Jul 2006
Posts: 178
Likes: 0
Received 0 Likes
on
0 Posts
if you press the buttons too 'slowly' it wont work. The flashing LED indicates an unexpected button press Theres a bit of a knack to it, you need to 'jab, at the button fairly firmly but quickly, and dont press the next button to soon/late after that.
Do you have the earlier keypad with the flush buttons or the later, raised type?. If the former, using a BLUNT prodder helps: the rubbesr on end of a pencil is ideal.
Are you remembering the * and #? in the programming code?
Do you have the earlier keypad with the flush buttons or the later, raised type?. If the former, using a BLUNT prodder helps: the rubbesr on end of a pencil is ideal.
Are you remembering the * and #? in the programming code?
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM