Was wondering if anyone fairly local to me would be able to help me fit (or at least set up) a dawes device. I've a fair idea as to how to do it but for safety reasons woul appreciate the knowledge of someone that has done this before

Thanks in advance
Steven

 

How's it going mate

Been caught doing any more dodgy deals in Lanark yet by plod , how funny was that.......

Good luck getting the Dawes fitted

 

Hi m8,

where abouts in Lanarkshire are you, I'm in Uddingston if you're not too far away I could give you a hand.

Scott

 

Hi Sipie, going well, can't complain thanks, what about you? I worked out why that filter looked strange, it says K&N on the side ........... so, anyone want to buy an ITG filter

I've been trying to cut down on the dodgy deals recently, arousing too much suspicion these days it seems, must be associating with dodgy people like you that's done it

Scott, cheers mate. I stay in Motherwell, i managed to fit it by looking at a few old posts and think it's setup right. It is registering 15.5psi peak and holding about 15psi in the higher gears, is this correct do you know?

Any help would be much appreciated
Steven

 

It sounds OK, do you have a AFR gauge fitted to make sure you have enough fuel for the increase in boost?

Scott

 

Hi Scott, i've got an afr fitted but haven't a clue where the signal wire goes to wire it up, that is all that needs done to wire it up, sorry to be a pest but would you be able to help me out there?

 

Depends what year your car is, I fitted one to my MY00 so I know where the lambda wire is on that but it differs on older cars. If you ask in the technical forum someone in there will know, that who I found out.

Scott