car has a k and n 57i induction cone filter on it but the filter is quite bashed up underneath as its not fixed properly,not stable so it must bump up and down.
how have you lot managed to keep it secure and not resting on anything?
also are there any other filters that are direct fit to this induction kit?

 

Hello mate if you go onto k&n website look your car up and view the install instructions it will show you what was ment to be in the kit and how it fits it sounds like your missing the large hose clip with stud and the metal connecting bracket. It will also show you the part number for the cone so you can re order a new one k&n are proven so id stick with it

Regards

Dave

 

ok, cheers, the car does have small metal bracket on water header tank but yes missing the large hose clip.

 

Its quite common that the stud snaps off the hose clip from over tightening. The bracket off the coolant bottle sounds like the little beasty.

 

oh ok ,so what do you do then when that happens? i might attack it with some big cable ties or something?

 

well you could order a new one from k&n same time you order the new cone or you could make something that does the same thing

 

You can only order the whole kit again.so will have to try and do something else.