Header tank thermal spacers
#1
Scooby Regular
Thread Starter
iTrader: (8)
Join Date: Sep 2010
Location: Reading,Berkshire
Posts: 907
Likes: 0
Received 0 Likes
on
0 Posts
Header tank thermal spacers
Hi all,
After my relative success with my bov adaptor plates I've made for a few on here ( in the GB page)
I have made a few sets of these for my local Subaru club out of black material , I now have some white ptfe also , which have all been taken and wondered if any of you would like a set that's in the picture below ,
Thermal header tank spacers
These help as a barrier for heat soak from your metal header tanks , the heat that travels through into your manifold , this warmer air isn't ideal for entering the throttle body
I'm not aware there are that many places making these simple little pieces
These are £13 posted for a set of 2 plus bolts washers etc
Thanks
Neil
After my relative success with my bov adaptor plates I've made for a few on here ( in the GB page)
I have made a few sets of these for my local Subaru club out of black material , I now have some white ptfe also , which have all been taken and wondered if any of you would like a set that's in the picture below ,
Thermal header tank spacers
These help as a barrier for heat soak from your metal header tanks , the heat that travels through into your manifold , this warmer air isn't ideal for entering the throttle body
I'm not aware there are that many places making these simple little pieces
These are £13 posted for a set of 2 plus bolts washers etc
Thanks
Neil
#4
Unmapped 12.4s @ 105
iTrader: (29)
Join Date: Apr 2005
Location: Newcastle. 330bhp-289lb/ft @ 1bar boost - 12.4s @ 105mph
Posts: 11,776
Likes: 0
Received 4 Likes
on
4 Posts
Neil, could you do them in a slightly different size, length wise? Actually, how long are they?
I only ask, as it would make it easier for people to securely mount the later metal header tanks, to PH1 manifolds as the mounting points are differently spaced.
I only ask, as it would make it easier for people to securely mount the later metal header tanks, to PH1 manifolds as the mounting points are differently spaced.
#5
Scooby Regular
Thread Starter
iTrader: (8)
Join Date: Sep 2010
Location: Reading,Berkshire
Posts: 907
Likes: 0
Received 0 Likes
on
0 Posts
These ones are 40mm long over all, but yeah I've made a custom set for them to bolt to a forge header tank they were 50mm long with staggered holes from one end
If anyone wanted custom ones , all I would need is the length and width they want
All holes are 8mm dia unless you want different
If anyone wanted custom ones , all I would need is the length and width they want
All holes are 8mm dia unless you want different
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM