mwscooby

Hi just wondering if someone could help me wire these up purchased from ebay a few weeks ago but wiring is just confusing me not sure were they all plug into as they were all unplugged when i bought them any help would be appreciated hope the pics work not sure how to put the pics up thanks







[IMG]file:///C:/Users/Mark/Desktop/morette%20headlights/IMG_0312.JPG[/IMG]


[IMG]file:///C:/Users/Mark/Desktop/morette%20headlights/IMG_0323.JPG[/IMG]

[IMG]file:///C:/Users/Mark/Desktop/morette%20headlights/IMG_0314.JPG[/IMG]

[IMG]file:///C:/Users/Mark/Desktop/morette%20headlights/IMG_0315.JPG[/IMG]

[IMG]file:///C:/Users/Mark/Desktop/morette%20headlights/IMG_0321.JPG[/IMG]

JonMc

iTrader: (51)

To show the pics get a photobucket or imageshack account and post the link codes

You'll get an image like this...



Hope it helps

albob

this thread is just for u !!!!!!!!!!

https://www.scoobynet.com/lighting-a...g-diagram.html

mwscooby

hope these pics work now

http://i1051.photobucket.com/albums/...y/IMG_0324.jpg http://i1051.photobucket.com/albums/...y/IMG_0312.jpg http://i1051.photobucket.com/albums/...y/IMG_0319.jpg http://i1051.photobucket.com/albums/...y/IMG_0317.jpg http://i1051.photobucket.com/albums/...y/IMG_0321.jpg http://i1051.photobucket.com/albums/...y/IMG_0315.jpg http://i1051.photobucket.com/albums/...y/IMG_0313.jpg

scoobymikepic

iTrader: (3)

HI MWSCOOBY,

HOPE THIS HELPS. WORKED ON MY WIFE'S 2002 BUGEYE,CHEERS SCOOBYMIKE..
…. SUBARU MORETTE HEADLIGHT WIRING ….


Subaru headlight system is common positive, switched ground. The wiring of the headlight connectors in the car is as follows-

Driver side- common positive = red/light blue (centre terminal on connector)
low beam switched ground = yellow/red
high beam switched ground = red

Passenger side- common positive = light blue/white
low beam switched ground = yellow/red
high beam switched ground = red


The wiring on the Morettes-

Common = gray
Low beam = yellow
High beam = blue

Both sides on the Morettes are the same colours. The gray common should be connected to the common positive for each side. The low and high beam wires should go to their respective switched grounds.

Also make sure the two wires to the battery are connected properly. The one with the inline fuse is connected to the positive terminal, the other one to the negative. Don't go by wire colour, the positive may be black.
And there are also the two wires that go from the driver side light to the passenger side. They have to be plugged into their mating connectors in the passenger side light, if they aren't connected the passenger high beam won't work.


Driverside-
Morette side plug into Factory harness side
grey plug into red/light blue
yellow plug into yellow/red
blue plug into red


Pass Side-
Morette side plug into Factory harness side
grey Plug into Light blue/white
yellow plug into yellow/red
blue plug into red

mwscooby

Thanks for the advice guys I am going to try and wire these up today don't know what is the best way yet though