camshaft position sensor needed
#1
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: Jun 2009
Location: stockport
Posts: 286
Likes: 0
Received 0 Likes
on
0 Posts
camshaft position sensor needed
for a 2001 wrx, mine is playing up really bad now, just had my engine rebuild so cant afford a new 1,
has anyone got a second hand 1??
has anyone got a second hand 1??
#2
Hi there's a few on ebay - i think the part number is 22056AA062. Or you could phone these guys. They were great when I used them for throttle sensor and idle sensor recently:-
http://www.imprezabreakers.co.uk/
http://www.imprezabreakers.co.uk/
#3
The Bugeye WRX and the new DENSO ECU which came with it was always a bit flakey when it looked at the Camshaft position sensor. Usually throwing a CEL near the rev limiter which went out after about 5 starts. The ECU does not go in to limp mode or do anything else so performance is not affected.
Most Camshaft position sensor CELs go away after a good clean as specks of dirt can fool the sensor
Have you cleaned it and is the car running OK ?
Shaun
Most Camshaft position sensor CELs go away after a good clean as specks of dirt can fool the sensor
Have you cleaned it and is the car running OK ?
Shaun
#4
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: Jun 2009
Location: stockport
Posts: 286
Likes: 0
Received 0 Likes
on
0 Posts
yer the car runs fine, keep getting the light on for a missfire on all cylinders(but its not missfiring at all), think its the netarul position sensor.
and cam sensor, all the time
only since the remap tho
and cam sensor, all the time
only since the remap tho
Thread
Thread Starter
Forum
Replies
Last Post
robbie1988
Wanted
2
13 September 2015 09:25 AM
Scooby-Doo 2
Wheels And Tyres For Sale
1
09 September 2015 06:51 PM