Cheap Mudflaps .. how to fit ?
29 September 2009, 07:07 AM
#1
Cheap Mudflaps .. how to fit ?
Mudflaps Subaru Impreza WRX STi Legacy mud flaps on eBay (end time 04-Oct-09 13:32:31 BST)
Bought two sets of these and the front are on and look good to be honest, very imprezed (lol)
There was a hole half way up the wheel arch and I just screwed into the plastic for the other screws .. seems tight and safe...
The back has nowhere to screw anything into .. how do you attach them there?
Someone must have bought some like this ?
Bought two sets of these and the front are on and look good to be honest, very imprezed (lol)
There was a hole half way up the wheel arch and I just screwed into the plastic for the other screws .. seems tight and safe...
The back has nowhere to screw anything into .. how do you attach them there?
Someone must have bought some like this ?
29 September 2009, 08:35 AM
#2
I fitted some and had 2 holes in the rear arch already, did yours come with the black poppers at all? I used a 6mm drill bit them put the poppers in(like what hold the arch liners in place but no centre pin)
If your stuck I have a few of the poppers left if you need them.
edited to add the seller has alot of mudflaps and most come with a fitting kit, did yours?
If your stuck I have a few of the poppers left if you need them.
edited to add the seller has alot of mudflaps and most come with a fitting kit, did yours?
Thread
Thread Starter
Forum
Replies
Last Post
JonMc
Subaru Parts
22
06 February 2016 09:50 PM
Scott@ScoobySpares
Full Cars Breaking For Spares
7
14 December 2015 08:16 AM
Danny0608
Subaru
6
27 September 2015 02:16 PM
Danny0608
Subaru Parts
0
12 September 2015 02:59 PM
