sti version 2 boost
#1
sti version 2 boost
What is the standard boost for a version 2 sti?
TSL decat downpipe (wrapped)
custom fabricated centre section
TSL Group N back box
Apexi Powerflow induction kit
Syntec Motorsport Fuel pump
Scoobyecu
The car is being fitted with an apexi avcr and i need to know what boost it will run safely.
TSL decat downpipe (wrapped)
custom fabricated centre section
TSL Group N back box
Apexi Powerflow induction kit
Syntec Motorsport Fuel pump
Scoobyecu
The car is being fitted with an apexi avcr and i need to know what boost it will run safely.
Last edited by g7prs; 18 September 2007 at 11:24 AM. Reason: update
#3
Should have added the car has this chip fitted aswell.
SCOOBY PRO ECU UPGRADE for Subaru Impreza...280BHP..... - eBay Performance Tuning Parts, Car Tuning Styling, Cars, Parts Vehicles (end time 16-Jun-07 10:33:46 BST)
SCOOBY PRO ECU UPGRADE for Subaru Impreza...280BHP..... - eBay Performance Tuning Parts, Car Tuning Styling, Cars, Parts Vehicles (end time 16-Jun-07 10:33:46 BST)
#5
I want to know the standard figures so i could set it to safe amount.
Not got any knowledge of these engines and just want to be on the safe side until i can save up for an Andy Forrest power fc and map.
#6
At 16psi (1.1bar) it should be fine as long as the fueling and ignition are taken care of (which they should be for that type of chip) and the octane rating of your fuel is sufficient for the map. If you are going for a PFC mapped by AndyF, it might be worth dumping the piggyback chip until it's done, if you have doubts about it's reliability?
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Car Parts For Sale
1
18 November 2015 07:49 AM