Forgive me for being short in this post.
I've got a Scangauge 2 in my car and need some assistance ASAP as I do not have the manual booklet on me as I am at work.

I had my mid section and back box changed today for something more "vocal" but not OTT rather than the Milltek system.

Anyway, since the drive back from getting it fitted my "engine management light" has come on display.
Now, the Scangauge is already plugged into the ECU port and I can run the "Scan" setting to check for fault codes.

Can anyone quickly run this by me as to the instructions for checking the fault codes and also what code points to what problem? I'd also require the link to a site that you can tell what fault code is what I think?
I don't think it will clear the code from the ECU full stop due to the software map or Will it?

Any help is grateful.
Cheers
Steve

 

http://www.scangauge.com/support/pdfs/SGIIManual.pdf

Subaru Trouble Codes - 1996 & newer Subaru-specific OBD-II Trouble Codes

maybe these can help.

 

Beastie,

I LOVE YOU.
XXXXXXXXXXXXXXXXXXXXXXX

Going to have a go in a second when I have a break. I think from memory isn't there only 30 readings on the scangauge?

Steve

 

Does this work on 99/00 cars, and will it display anything relating to MAF output ?

 

Hello mate,

I will work on 99> UK/Euro spec cars but for some reason it will not work on JAP Imports.
Can't say about the MAF but does show air ratio on the scangauge. So I guess it is the MAF reading?

Steve