J_sca001

Had my MY01 Import STI dynoed today.

Can't believe the result!!

Had it done at Powerstation. They were very helpful and polite, wondered if that bad press thread would make a difference, it did!!!

Anyway, the result was 326.9 BHP and 293 LBS torque!!

Can't believe it!!

Only had a K&N 57i induction and a complete de-cat and 3 1/2 Remus exhaust!

Over the fookin moon!!!!

1168

result

AFRIKANZ

That's really good mate!

wrxcraig

nice one, gona tack a trip to powerstation soon

Mangel

When you say dynoed, do you just mean measured or remapped, just out of interest!!?

J_sca001

Just a "Power run" to check all is well and what Torque and bhp is has. I'm well pleased!

J_sca001

Thanks folks! It explains why i seem to run out of petrol so quick when i put my foot down!

nickyrhodes

nice 1

its impressive what you can get from small mods on these cars. I got around 50bhp on mine from filter and exhaust too, even the guy who tested it was shocked!

J_sca001

Just looked at your Scooby! Very nice!

prince_of_tokyo

f**king hell m8, what a result eh...congrats

id be chuffed if i get anywhere near your output

jayltee1

Anyone recommend a good place close to Reading to get my motor checked out for power, etc? I am interested to see if it is running as it should. Also - what kind of money are you looking at to get it done. Nothing fancy, just a simple BHP/torque output.
Ta.

Multijfj

Only around £60 odd, nothing major. However I have no idea around reading, I am sure someone will come up with a place near there!

J_sca001

Cheers Prince!

Really shocked, for the right reasons

Let us know when you have yours done and what it puts out

prince_of_tokyo

definately will m8, not this staurday but saturday after...if you dont mind me asking how much do powerstation charge for a power run???

TDI were asking £160, got mine booked with powr engineering in uxbridge for £52

jayltee1

I just found DSA in Aylesbury and Paramount in Slough - both were around 55-60+VAT. One of them said I could use the equipment and play myself for 100. Prefer someone who knows what they are doing though!

J_sca001

£160! thats outrageous!!

Charged me £50.00

prince_of_tokyo

yeh, £160 because they apprently have some state of the art hub mounted dyno

Terminator X

iTrader: (7)

Surrey Rolling Road are near(ish) Reading.

TX.

marmski

If its an Import.. does that mean its had its UK Fuel Remap?

When replacing the Filter and De-catting... shouldnt you have a re-map? Im wondering if its 'safely' producing those figures.. without being close to going bang?

Awesome result if it is safe though

J_sca001

Good point. The fueling was checked at the same time as this was my worry to. I'm told it does lean out slightly at the very top end of the rev range but nothing to worry about. The power peaks at 7.5k anyway so no need to wring it's neck anymore.
Thats why i only did the induction kit and De-cat exhaust, didn't want to spend a fortune on mods.

marmski

Fair enough... be careful at that top end then... and congrats on the figures

J_sca001

Cheers mate!