My car is due to be mapped this Friday by Simon (JGM), here is a list of mods. Is there anything else i could add before friday. Base car is a sti v3

P1 bottom end with v9 crank
Inlet manifold spacers
denso 550cc injectors
fuel lab fpr
parallel fuel rail mod
walbro fuel pump
gruppe s v2 wrapped headers and up pipe
3" wrapped decat downpipe
Blitz nur spec r cat back
MD195s turbo
apexi power fc
apexi avcr
k&n induction
samco silicone induction hose
autobahn88 fmic with wrapped pipes
breathers to be vented to atmosphere

Car will be mapped for v power and millers octane booster. Hoping to hit 400bhp if possible.

Banny

 

what sort of clutch are you running?

 

I am running and exedy hyper clutch, the pedal has an oe feel to it but the clutch bite is much stronger. Running a standard flywheel.

Banny

 

Having looked through a number of post's and websites about mapping most mappers prefer not to map to a octane booster. This is primarily due to if you cannot get some then the settings would be off when on boost thus possibly resulting in engine rebuild. Might be worth asking the mapper prior to going with it in the tank. My bugeye was mapped on optimax only then if giving it plenty I add a bottle of millars for that bit of safety. Just a thought Steve.

Currently running 360bhp with just an exhaust, induction, FSE reg, headers, FMIC and GEMS with the obligatory uprated fuel pump. Looking at turbo in the future so good luck and hope you get what you want

 

Hi Steve i did want to run with a 10% methanol mix but decided against that, as the car is a daily driver. Seemed like a lot of hassle at every fill up. Will speak with Simon before mapping and take it from there. Thanks for your input though.

Banny