Pipe question
#1
Scooby Regular
Thread Starter
iTrader: (2)
Join Date: Jan 2006
Location: N.I
Posts: 480
Likes: 0
Received 0 Likes
on
0 Posts
Pipe question
Hi all,
Can anyone tell me the correct sizes for the actuator pipes and boost solinoid pipes. They are located on teh drivers side at the suspension joint there is three pipes. Problem is mine have all went hard over time (1993 wrx import) so i need to replace them but dont want to take then off until i have the replacment ones.
Also does fitting 17" or 18" alloys make much difference to performance compared to the standard alloys.
Thanks all
Drew
Can anyone tell me the correct sizes for the actuator pipes and boost solinoid pipes. They are located on teh drivers side at the suspension joint there is three pipes. Problem is mine have all went hard over time (1993 wrx import) so i need to replace them but dont want to take then off until i have the replacment ones.
Also does fitting 17" or 18" alloys make much difference to performance compared to the standard alloys.
Thanks all
Drew
#2
Scooby Regular
iTrader: (2)
Join Date: Sep 2005
Location: I want a Spec C!
Posts: 1,897
Likes: 0
Received 0 Likes
on
0 Posts
i think they are 3mm, demontweeks do some silicon replacement for not much money i think
as for wheels, 17 are ok if you keep the same rolling radius as std, but it's generally thought that 18's spoil the handling on a classic
as for wheels, 17 are ok if you keep the same rolling radius as std, but it's generally thought that 18's spoil the handling on a classic
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Flat4x4-again
General Technical
2
29 September 2015 06:32 PM