Cassic bits
Pair of OEM 4 pots with Ferodo 1155 pads (not had much use) and EBC 297mm grooved & spotted discs. Provisionally sold
Set of Ferodo 1166 pads for OEM four pots. Almost new. Provisionally sold
4 OEM 16” Alloys with Toyo Proxi T1-S. Alloys not brilliant tyres a couple of months old so nearly new depth.
HKS Racing Suction Kit from MY97/8
OEM 2 port boost solenoid MY97/8
OEM Idle Control Valve MY97/8 Provisionally sold
Nitosport Gear Lever Gaiter & Alloy Surround
OEM Headers (can gas flow them if reqd.) Up-pipe & Resonated Centre
Sensible offers please by PM or e-mail
Set of Ferodo 1166 pads for OEM four pots. Almost new. Provisionally sold
4 OEM 16” Alloys with Toyo Proxi T1-S. Alloys not brilliant tyres a couple of months old so nearly new depth.
HKS Racing Suction Kit from MY97/8
OEM 2 port boost solenoid MY97/8
OEM Idle Control Valve MY97/8 Provisionally sold
Nitosport Gear Lever Gaiter & Alloy Surround
OEM Headers (can gas flow them if reqd.) Up-pipe & Resonated Centre
Sensible offers please by PM or e-mail
Last edited by Houghton; Jan 1, 2005 at 01:17 PM. Reason: Can't spell classic
John,
I'm looking for £45 + postage for the gaiter. Don't know if it'll fit MY93
I bought it for my car JDM MY97 and it's too small. Below are the dimensions, it's really smart and would have looked very nice instead of the ugly lump of rubber that's fitted.
Dimensions: Length = 145mm x width 110mm tapering to 100mm These ae the outside dimensions so the hole needs to be about 10mm smaller all round.
I'm looking for £45 + postage for the gaiter. Don't know if it'll fit MY93
I bought it for my car JDM MY97 and it's too small. Below are the dimensions, it's really smart and would have looked very nice instead of the ugly lump of rubber that's fitted.
Dimensions: Length = 145mm x width 110mm tapering to 100mm These ae the outside dimensions so the hole needs to be about 10mm smaller all round.
Thread
Thread Starter
Forum
Replies
Last Post



