dazdavies

iTrader: (22)

As above,

I have for sale a refurbished Spec C Manifold and a pair of Billet rails with adaptors modified to suit the Spec C Inlet.

The manifold was stripped and cleaned and then painted with Frosts VHT Black Wrinkle. Finish looks factory as you will see from the photos.


The rails are hi flow black anodised billet aluminium and will come already attached to the manifold. All you'll need to do is pop some injectors in and you're good to go.

£300+ postage for the lot. Will include matching cable throttle body for an additonal £50

F1 CJE UK

iTrader: (8)

have these been done at RCM ? looking for a set to fit a 2.35 motor that rcm are building me will these do the job ?

dazdavies

iTrader: (22)

No not done at RCM but they'll be upto the job. I was going to use them myself except I've just sourced a Jap spec engine with empty TGV cases. This will allow me to use the Cosworth manifold at a later date. So I'm going that route.

F1 CJE UK

iTrader: (8)

any idea of the cost to make them red again, where did you get them done the finish is very good.

dazdavies

iTrader: (22)

The issue with the red is that the paint makers (Frosts) have recently changed the formula and this has resulted in a change of colour to a brighter more orangey red.

The old recipe was an exact match for how they came out of the subaru factory.

I was speaking to Matt about this on my last visit t RCM . They have stock of the correct paint but I don't know how long that will last for. I only went with black because it looks loads better than the new red colour.

F1 CJE UK

iTrader: (8)

ok thanks for the info, will keep an eye on the thread, sure some one will snap it up tho it looks perfect if it had been red i would take your hand off.

dazdavies

iTrader: (22)

OK Just the manifold is for sale now £150 delivered.

dazdavies

iTrader: (22)

Manifold now sold thanks